Original REMdevice accessories: Monitor Tester, anemometer, wireless battery charger, protective pouches and antennas.
Monitor Tester
Self-powered display device to be connected to the receiver, designed to read the remote control's operating data. Supplied complete with 9 V battery and connecting cable.
- Information displayed — working frequency and channel, signal and interference levels, number of starts and hours of operation, number of up/down and other commands (T series), relay diagnostics, active commands
WIND DIN 2 Anemometer
Omnidirectional digital anemometer for measuring wind speed, designed for installation on lifting equipment. Available in km/h and mph versions, with display for wind speed reading.
- 3-cup sensor — vertical axis of rotation, stainless steel shaft and bearings
- Two alarm thresholds — factory settings 50 km/h and 72 km/h (31 and 45 mph)
Technical Specifications
| Measuring range | 0–99 km/h (0–99 mph) |
|---|---|
| Visualisation | 2-digit display |
| Power supply | 48 Vac |
| Enclosure | Modulbox for DIN EN 50022 rail mounting, IP20 |
| Dimensions and weight | 70×75×90 mm – 350 g; wind sensor 120×80 mm – 140 g |
Wireless Battery Charger
The patented wireless charging system does away with electric contacts entirely, ensuring greater operator safety and preventing failure due to dust and moisture. In just 5 hours it fully recharges the transmitter units' internal batteries; a temporary 30-minute charge gives the remote control enough power for a whole working day. A microchip inside adjusts the energy delivered to ensure maximum battery efficiency. The same charger can be used for Brick, Pail and Genesis.
Compact version. The new compact charger unit offers the same performance and features as the standard model; small and compact, it can be used in vans, trucks and PC USB sockets (95×15×120 mm, 120 g).
Technical Specifications
| Oscillator | automatically current controlled |
|---|---|
| Supply voltage | 230 Vac (115 Vac version for the American market) |
| Current demand | 0.1 A |
| Housing | IP55 – PA6 GF V0 |
| Dimensions and weight | 135×85×190 mm – 790 g (complete with mains cable with A-type USB plug) |
Protective Pouches
Protective pouches available with and without belt for Brick and T Series remote controls.
Antennas
Three models that vary depending on the working frequency.
UHF — Rugged and reliable, waterproof, suitable for all applications. Comes with a standard 1.5 m cable and SMA or SMB connector depending on the model.
FLAT 870 — Panel antenna with microstrip technology for special applications requiring the signal to get around obstacles and greater directivity for an improved signal-to-noise ratio. Standard 3 m cable and SMA connector.
WHIP — For applications where the signal has to get around shielding obstacles. Standard 3 m cable and SMA connector; supplied ready for mounting on a pole or equivalent support.
Technical Specifications
| UHF | 418 / 433-434 / 870 / 915 MHz – 5 dB – IP65, PA6 FV – 128×72×50 mm – 140 g |
|---|---|
| FLAT 870 | 863–870 MHz – 14 dB – panel – 240×25×240 mm – 800 g |
| WHIP | 418 / 433-434 / 870 / 915 MHz – 8 dB – 35×450×35 mm – 310 g |
